PRODUCTS / Ultrasonic / Precision Gage / 35 Series, Transducer, Acc's /

35 Series, Transducer, Acc's

35 Series, Transducer, Acc's

35 & 35DL

Models 35 and 35DLare used in the majority of applications. The 35 and 35DL can use transducers ranging from 2.25 to 30 MHz, which means that these versatile gages can solve the majority of thickness gaging applications, from very thin to very thick. In general, transducers with higher frequencies and smaller diameters allow measurements of thinner or curved parts and enhance the accuracy of the measurement.

Applications:

  • most materials, from thin to thick
  • plastic bottles, tubes, pipes, sheets as thin as 0.08 mm (or 0.003 inch)
  • metal containers, steel coils, machined parts as thin as 0.10 mm (or 0.004 inch)
  • cylinder bores, turbine blades
  • glass bulbs, bottles
  • thin fiberglass, rubber, ceramics, and composite materials
  • curved areas or containers with small radii
  • resolution up to 0.001 mm or 0.0001"

35HP & 35DLHP

With a very low ultrasonic frequency bandwidth and a special pulser-receiver, the HP gages are specifically designed to optimize ultrasound penetration when measuring thick, highly sound attenuating or sound scattering materials. Typically these materials cannot be measured with most other ultrasonic thickness gages.

Applications:

  • most thick or sound-attenuating materials
  • thick cast metal parts
  • thick rubber tires, belts
  • fiberglass boat hulls, storage tanks
  • composite panels
  • resolution of 0.01 mm or 0.001"

Transducers & Accessories

Panametrics- NDT™ offers a complete selection of transducers, cables, couplants, calibration test blocks, and accessories to meet a wide variety of ultrasonic precision thickness gaging applications.

Panametrics- NDT™ Microscan transducers are frequently used with the Series 25 and Series 35 thickness gages, as well as other commercially available thickness gages, flaw detectors and ultrasonic instrumentation.

Click below lists for more information on available transducers:

Immersion & Bubblers

Panametrics- NDT™ RBS-1 immersion tank is designed to simplify ultrasonic thickness measurements using immersion techniques. It consists of a clear acrylic tank, a submersible pump and a transducer fixture in a single, portable unit. It is ideal for offline thickness measurements on metal, glass and plastic products such as small containers, pipe or tubing, sheets or plates or machined parts.

Panametrics- NDT™ offers bubblers for easy implementation of immersion testing. They act as a holder for the transducers to maintain consistent water flow from transducer to test surface, and prevent the accumulation of air bubbles on the transducer face. Handheld bubbler transducers are available in either 20 MHz (V316B) or 10 MHz (V312B). They are immersion transducers that screw onto a bubbler assembly (B120), which has a replaceable stainless steel tip and a water feed tube. They offer high resolution and easy access inspection of thin materials.